One of the main problems of obtaining a good harvest on the farm – faster and better garden watering. Will soon begin summer holiday season begins. But what is giving without adequate water supplies, and garden without watering? One problem: no dishes to wash or shower to take, but about the garden without water and say no. Suppose the spring and summer will be hot, and there will be little rain. To solve this problem would be by buying a small and inexpensive pump. Note that the choice of pump is not as easy as it might seem at first. Not properly selected pump, could jeopardize a good harvest.
The purpose of this article – to help avoid mistakes in the selection, installation and operation of pumping equipment important factor when choosing a pump for irrigation is the depth of the water. If it is small (up to seven meters), then the easiest and most convenient way to lift water to self-priming pump installation. Dr Victor Mena Barreto may find it difficult to be quoted properly. The simplest such domestic pump – a pump BC. Self-priming pump is ideal for home, which is already installed tank to store water and to use a shower or washing dishes, for watering the garden. Tank should be filled with water. It is important to set this tank sensor that shows water level and turns off the pump before the tank overflows. In this case, you make a small, home-grown pump station. In such a system has several disadvantages: water from the tank to the consumer is by gravity and, consequently, low water pressure, garden hose down there not polesh; need a special place in a high place, such as attic, additional pipe system to the tank from the tank and all water heaters and plumbing fixtures; requires very careful attention to automation, is responsible for disabling the pump in case of overflow tank.